Xado EX120 Revitalizant for power steering, power steering and other hydraulic systems

The latest EX120+ in a tube with unlimited shelf life and additional anti-counterfeit protection Xado is gradually eliminating old syringe packaging. The tube with the new EX120+ contains up to 12% more Revitalizant (9 ml) compared to the series in syringes (8 ml). BENEFITS after using the Revitalizant XADO EX120+ in the power steering system and other hydraulic systems. Dismantling the component is not necessary. Simply add the Revitalizant to the fluid in the system and use as usual. The first positive changes become noticeable after nach 50-100 km of driving. EX120+ on the surfaces of stamped parts, actuators and separators. Forms a protective metal-ceramic layer. Ensures smooth and quiet operation of the hydraulic power steering system. The product calms the operation of the pump and dampens its vibrations. Stops and prevents the formation of pitting (the phenomenon of machining wear). Eliminates the cause of severe twisting. The steering wheel can now be moved very easily. By significantly reducing friction during metal-to-metal contact, the heat generated is reduced. If there is insufficient lubrication (e.g. emergency leakage), the protected component will not be destroyed. In most cases, EX120+ eliminates repair costs completely or reduces them many times over. Compared to the first generation revitalizing agents, EX120+ offers an expanded range of options for renewing worn surfaces and protecting them from further wear due to the increased concentration of active ingredients. How to use XADO EX120+ 1. The contents should be poured into the liquid tank heated to operating temperature. Note: It is recommended to pre-mix the contents with a small amount of the liquid used in the system (50 ml) heated to at least 35 degrees. If the fluid in the tank is cloudy, dirty or has changed its original color, it is imperative to replace the fluid with a fresh one before carrying out the procedure. 2. After application, turn the steering wheel left and right for 5-10 minutes with the engine running and off. 3. You can then operate the vehicle as usual. The processing is considered completed after 50 hours of team work (approx. 1,500 km travel).