XADO Atomic Metal Conditioner Engine Oil Additive 225ml Revitalizant Highway

A product that helps to keep losses as low as possible and thus overcome the engine's own resistance Product features A product that helps to keep losses as low as possible and thus overcome the engine's own resistance If you have already used AMC Maximum and changed the oil again, the addition of HIGH WAY ensures a low internal engine resistance The amount of Revitalizant is reduced to 5.5% compared to Maximum, the amount of the other two, which are removed by an oil change, has been retained Also the price is correspondingly lower When use? If your car's engine has undergone a complete revitalization cycle and oil consumption has stabilized at the factory level. If you want to change the oil, add the replaced AMC immediately at the time of oil change or shortly after oil change. Why? A two-phase metal conditioner ensures smooth operation of the engine and therefore good sound insulation. They ensure permanently lower fuel consumption. They obtain better flexibility when accelerating faster and from low speeds. It provides additional protection at friction points and, thanks to the presence of a revitalizing active ingredient, ensures continuous residual renewal resulting from wear and tear during use. 1 slip factor (fluid) – ensures extremely good sliding of the surfaces against each other and lower losses when pumping oil – anisotropic oil flow in the gaps between the friction surfaces. 2 Revitalizant (granulate) - builds metal-ceramic on surfaces, equalizes spatial wear and increases wear resistance Metal conditioner (liquid) - a highly adhesive ingredient that protects rubbing surfaces How it works: The Revitalizant forms a metal-ceramic layer on friction surfaces that compensates for wear and thus extends the service life of the interacting parts The molecules of the two-phase, comprehensive metal refiner (2D factor) are synergistic (reinforcing) interaction with the revitalizing nanoparticles and the material of the cooperating surfaces. This transfers the three-dimensional contact between surface roughness into the two-dimensional - in planes with very good sliding properties and therefore a very low coefficient of friction. Recommended for engines that have already gone through a revitalization cycle. It is added to the oil at a time in the amount of 225 ml per 4-6 (maximum per 10 liters) liters of oil. It is best to change the oil for the next one Oil change to fully utilize the removed ingredients Add it by pouring the oil into the engine warmed to operating temperature Do not exceed the “MAX” mark on the dipstick