Windshield repair kit to detect cracks or damage in the glass

Glass Repair Kit Windshield Repair Kit It is designed to easily fill in pinpoint cracks or spider-shaped damage on the glass. Thanks to the set you will eliminate the problem of subsequent chipping/cracking of the glass. The resin included in the kit fills the chips on the glass and, when in contact with the sun's rays, leaves a completely transparent shape after curing. By using the set, the chips on the windshield are hidden so that they are invisible and do not interfere when driving. It also prevents the splashes from getting bigger. Thanks to the repair kit, you don't have to worry about your car having to replace the entire windshield due to stone chips on the windshield. Application: 1. Remove loose glass particles from chips (hole in a crack) with a needle. Also clean the entire area around the diameter of the damaged area. 2. Apply the adhesive sealant to the glass where the chip is located. To do this, peel off the protective film on one side of the seal. Install the gasket so that the spatters are in the center of the hole and the tab is facing up. Press the seal firmly against the glass. 3. Peel off the protective film from the top of the seal. 4. Mount the stand on the gasket so that the tabs overlap. Make sure it is pressed firmly against the gasket. 5. Pour the contents of the resin tube into the holder through the opening at the top. Leave some resin for the final repair step. Wipe off any excess resin and close the resin container. 6. Insert the syringe into the top opening with the plunger fully depressed. Make sure it fits well. 7. Draw air from the base by holding the syringe barrel with one hand and lifting the syringe plunger with the other hand. Lock the piston by snapping the first wedge onto the spring clip. Release the syringe and let it stand for 10 minutes to suck out all the air. 8. Pull out the syringe and draw air into it. Reset the syringe and check if it is stuck. 9. Push down on the syringe plunger and lock the other wedge by rotating the plunger against the spring clip. Leave the syringe blocked for 20 minutes. Then pull out the syringe. 10. Use a razor blade to cut the edge of the base and peel it away from the glass. Remove any excess resin that drips from the glass. 11. Apply one or more more drops of resin to the area of ​​the chip and apply a clear film of hardener there, squeezing out any air bubbles from below. 12. The disc with the resin so applied should be exposed to sunlight for at least 15 minutes to allow the resin to harden. When the resin has hardened, gently scrape off the hardening film and excess resin with a razor blade. The kit includes: a syringe - a spring clamp - a wedge - a tube of filler - a razor blade - a self-adhesive gasket - a piece of self-hardening film - a needle for cleaning the crack site. NOTES: 1. Do not use in direct sunlight. 2. Do not apply to hot glass. Store in a shady place. 3. The razor blade included in the set is required to remove the adhesive residue. 4. Do not let the resin come into contact with painted elements.